Guide :Optics : Aries 390 Paladin Weapon Sight

Grouping havn trouble zeron and getn a good grouping at 100 yards. using a bruno 243 rifle

Posted by ohalloranpad on Sep 14, 2008

Research, Knowledge and Information :


How to Properly Zero a Rifle in Five Steps - Guns & Ammo


Want to know how to properly zero a rifle? ... is that a 25-yard zero will be about right at 100 yards, ... I know some good riflemen zero at 200 yards and ...
Read More At : www.gunsandammo.com...

How to Sight the Scope of a Rifle in and Zero It: 6 Steps


How to Sight the Scope of a Rifle in and Zero It. To get the ... set your target at 25 yards/meters and 100 yards/meters. Secure the rifle ... Find the shot grouping ...
Read More At : www.wikihow.com...

10 Shooting Tips From Army Marksmen - Quality Deer Management ...


10 Shooting Tips From Army Marksmen. ... a good cleaning is in ... notice that at 100 yards, you can zero your rifle about 1.75 inches high and be about right for ...
Read More At : www.qdma.com...

How to Sight-In a Hunting Rifle - CHUCKHAWKS.COM


How to Sight-In a Hunting Rifle ... rifle has been bore sighted for 100 yards it is time to go to the rifle ... flyers so that you have 3 good shots on the ...
Read More At : chuckhawks.com...

How to Zero Your Rifle Scope: 15 Steps (with Pictures ...


Dec 29, 2016 · How to Zero Your Rifle Scope. ... Examine your shot grouping. ... Sight the Scope of a Rifle in and Zero It. How to . Sight In a Rifle.
Read More At : www.wikihow.com...

Shooting - Group diagnosis - rifleman.org.uk


Shooting group diagnosis ... of three shots in a tight cluster in the centre of a group does not indicate a good rifle, ... but they mean an inch at 100 yards.
Read More At : rifleman.org.uk...

Gun Review: Ruger American Rifle - The Truth About Guns


Using a bipod I was able to get a 1 MoA group at 100 yards. Good enough for ... Gun Review: Ruger American Rifle. ... thus far. i have about 4″ grouping at 300 yards.
Read More At : www.thetruthaboutguns.com...

Suggested Questions And Answer :


Nothing but Pitch black


I Have two Mk 6500 they are both pitch black inside. YES i put new battery in same thing. Is there a way I can fix this my self, they want $800.00 to fix one at ATN... these are not junk scopes..
Read More At : Aries 390 Paladin Weapon Sight...

When is best time to sight in ATN 390? - ATN Aries 390 Paladin Weapon Sight


At night. You can sight in the 390 during the day in simi-darkness with a day light lens cover over the front of the scope. (the snap cover has a small hole in the center for look see during the day) 50 foot room with a target, bench rest and a rifle vise. You'll also need laser bore sight Figure you rifle ammunition ballistic and how many yards before it starts to drop. Set the 390 reticle to the red do on the target one or two inch above. Dead center set up will give you about two hundred yards on center... approx. Now you know this is a static test or sight in. During night because of some distortion and noise from the scope. stewbison
Read More At : Aries 390 Paladin Weapon Sight...

1. HOW TO READ SCALING OF SCOPE.? 2. What is


You have not provided enough information for us to help you. What type of rifle? What do you mean by scaling? With the scope on 3 power you should be able to sight it in at 25 meters. Going to a higher magnification may cause blurring at that distance.You also may have mounting problems that are causing the scope to move around when you shoot. Your rifle may be fine.
Read More At : Trophy 3-9x40 Rifle Scope, Matte Finish Rifle Scopes...

Aries 390 Paladin


Tubes can go without warning, but power supplies usually do. Get someone to check if PSU takes a current at switch on and then measure the HV.
Read More At : Aries 390 Paladin Weapon Sight...

There is not picture its just vioce - ATN Aries 390 Paladin Weapon Sight


Battery OK, IR light up, no green image on the intensifier image tube, correct! What type of voices are you hearing? Give ATN Aries 390 two Zolof and wait two day, just kidding!!! The noise is a crackling, high freqencey hum, popping, etc. Also remove the eye lens, it screw off, then remove the scope to someplace where it semi dark. Turn it on and observe the 18mm white plate and see if it turn green---no green---no look see---no image intensifier tube, it dead that is the mage tube. stewbison.
Read More At : Aries 390 Paladin Weapon Sight...

I have a Bushnell Elite 4200 6x24x40 rifle scope 42-6242M


First is to try for a group, do not adjust the scope in any way. Shoot 4 rounds with out adjusting the scope. The gun should settle down and start to group. If you can not get a group in 6 rounds go clean that gun & check your ammo. Start over. If she does not group, its the gun not the scope. Once it starts to group move the cross hairs in the opp direction small clicks and "TAP' the scope after each adjustment. Shoot for a group each time 2 rounds should group. Get a target that has a grid to help get on faster. 
Read More At : Elite 4200 6-24x40 Riflescope w/Adjustable Objective...

Question about Swarovski Scopes


Iv had this problem many times before,,,its more likley to be a bad set of mounts not inline with the barrel,,, if you have ran out of windage adjustment,, to get over it i use a strip of 35mm film inside the scope mount to push the scope over a bit,,, but a new set of mounts would be the best way forwards
Read More At : PH6-24x50 Weapon Sight...

Lost eye piece to rifle - ATN Aries Crusader MK7900 Weapon Sight


Contact ATN Enterprise in CA. stewbison
Read More At : Aries Crusader MK7900 Weapon Sight...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.opticinfobase.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0897 seconds