Guide :Optics : StarHopper 10 Telescope

Where to find the gearbox for the 1994 celetron dec motor gearbox

Posted by gtibbetts on Jul 08, 2008

Research, Knowledge and Information :


Nexstar 4 gearbox compatibility - Celestron NexStar - Cloudy ...


Nexstar 4 gearbox compatibility ... can I use the motor/gearbox from a 4SE on a 4GT mount? That part is available on Celestron's online spares list, ...
Read More At : www.cloudynights.com...

Celestron Advanced VX gearbox adjustment - YouTube


May 07, 2013 · Celestron Advanced VX gearbox adjustment ... Celestron CGEM Mount RA Motor Troubleshooting - Duration: ... Celestron Advanced VX Mount moving sound ...

All Spare Parts - Celestron


Products. No matter what you need to see, Celestron has an optic for everyone. Browse our extensive astronomy, sport optics, and microscope product offerings here.
Read More At : www.celestron.com...

CGEM DEC motor backlash - YouTube


May 31, 2012 · CGEM DEC motor backlash ... but in fact the gear had slop from inside ... Celestron Advanced VX gearbox adjustment - Duration: ...

Working 5 speed transmission model for Toyota 22RE engine by ...


Dec 30, 2015. Gandalfthefab ... Working 5 speed transmission model for Toyota 22RE engine ... The original 3v motor will still work with the transmission attached, ...
Read More At : www.thingiverse.com...

manual gearbox for 1994 80 series | Land Cruiser Club


manual gearbox for 1994 80 series. Steve10 Dec 31, ... So that if Steve was to install a manual gearbox in ... Or are you guys saying that it will struggle at motor ...
Read More At : www.landcruiserclub.net...

Mechanical Gearbox Archive-Repair Manual - Alamo Industrial


Mechanical Gearbox Archive-Repair Manual An Alamo Group Company ... Apr, 1991 to Dec. 1994..... 40 - 43 00769115..... Jan. 1995 to Current ...
Read More At : www.alamo-industrial.com...

Users manual: Mitsubishi Delica SpaceGear


Edition E12 December 2005 1 Credit: ... Gearbox must be in park mode (P). (2) ... use the motor drive to bring it fully in, and
Read More At : manualov.net...

Spare Parts Telescopes, Solar Telescopes, Binoculars ...


LX90 Dec. Motor Driver Board ... Spare Parts. Showing 1 to 15 of 35 total. ... LX600/LX200 R.A./Dec. Motor Gearbox (16" models) Out of stock.
Read More At : www.meade.com...

Suggested Questions And Answer :


I have an issue on my meade ET90 AT. I have a motor failure message after the telescope try to find a star. Now when I turn on I received a message from the autostar to press 0 or mode in both case it start the test motor and appear the message Motor fault. I change the batteries but it doesn't change the result. When I turn on and I received the message "0 or press mode" if I try to push the arrows button the telescope move right and left but no up and down. I called the meade customer service and after 30 seconds they told me to bring the telescope to their repair center. Thanks


Try this.1. Do a RESET on the hand controller.2. Reenter your Site, Date, and Time.3. Calibrate MotorsNow see if that fixed it. If not it will need to be returned to Meade because a gear or circuit is broken inside the scope.
Read More At : ETX90AT Maksutov Telescope with UHTC (cat35140321)...

Where to find the gearbox for the 1994 celetron dec motor gearbox


Starhopper does not have a gearbox - strictly manual.
Read More At : StarHopper 10 Telescope...

Telescope broken hi. i recently started using my meade DS-2000 series telescope that i bought 4 years ago. it was working fine except that the motor would not move the telescope vertically. i took it apart to see if i could fix it like most of my toys that don't work, but it looks like some pieces that are supposed to be welded together aren't, and a plastic gear is loose on a metal piece meant to be welded to the part that hooks onto the telescope. i couldn't find a replacement part, on the internet, so if you have any suggestions, please let me know.


You will not find parts for these telescopes-- however Meade can repair them if you send them in.Meade does not sell parts for their telescopes --http://www.meade.com
Read More At : Optics...

C10-NGT RA+DEC clamps and the motors


Holy man.. response is kinda slow. Good thing I tried it myself. Sure as heck, you can leave the Right Ascension and Declination clamps tight while using the motors!It makes a lot of sense, and many things much easier....Thanks for the.. reply? lol. Just joking.=)
Read More At : Advanced C10-NGT (600 x 254mm) Telescope...

Meade lx-90 dec printed circuit board bad. where


Since you already disassembled the scope-- you can send the board to Ron Sampson and he should be able to repair it. He fixes main boards and hand controllers (including the screen and keyboard on the hand controller!)If you post a message on the Yahoo LX90 group looking for Ron Sampson he will answer you. You can then email or phone him for instruction on how to send him the board.ARE YOU SURE it's the board? It could be a bad keyboard or a bad cable on the hand controller. You should get another hand controller and cable and test it before you send it off. Can you borrow a hand controller and cable from anyone.... or from a local scope retailer?
Read More At : 8 Inch LX90 LNT Schmidt Cassegrain - Standard Coatings -......

Replace connector on wire from DEC drive Motor on a LXD55 telesco


If you will post this question on the LX forum on:www.cloudynights.com someone will know the proper sequence and color to reattach.
Read More At : LXD55 Telescope...

Bolt holding dec drive motor on 16 loosens.


You have a LARGE Meade telescope. This should be an easy fix if you can disassemble the fork arm and get inside.First I would contact Meade customer service to see if they have a manual that shows disassemble instructions. If not I would join the Yahoo LX200 forum and look for help there with an owner of the 16 inch model.http://www.meade.com/support/index.htmlJust search in Yahoo Groups for the LX200 forum.On smaller scopes the DEC motor is held on by two spring loaded bolts, probably one has become loose?
Read More At : LX200GPS Telescope...

Motor Doesn't appear to move the telescope & battery problem


Hey Bill, if you have a manual it should be in there. If you don't go here. http://www.bushnell.com/products/other-products/telescopes/instruction-manuals/ Good luck.
Read More At : NorthStar 78-8846 (675 x 114mm) Telescope...

Meade lX90 scope finding problem


Go back to square one-- in this orderRESET the hand-controllerCalibrate MotorsTrain Drives in BOTH axisEnter Time, Date, and Site-- Daylight Savings NO -- right now in the USACalibrate sensors (if you have this option)Then do a two star Automatic alignment-- you will need to CENTER each alignment star and they may NOT be inside the eyepiece but nearby.Here is a manual-- http://www.meade.com/manuals/TelescopeManuals/LXseries/LX-90_manual.pdf
Read More At : Optics...

LX90 Dec pointing out by 4 degrees over run


Go onto www.cloudynights.com and post this in the LX member forum-- and or go on YAHOO groups and post this in the LX90 forum--Are you absolutely sure that your TIME and DATE and DAYLIGHT SAVINGS (yes-no) are correct.On my LX90 the first alignment star is always NOT in the eyepiece but everything is OK once I center both alignment stars.
Read More At : 8" LX90 LNT Schmidt Cassegrain Telescope with SmartFinder w/......

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.opticinfobase.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0898 seconds